How To Hang Your Ceiling Fan - Fanimation Tropicana FP1600 Series Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

CEILING
FLOOR
Figure 4
RUBBER
PAD (2)
HANGER
BRACKET
SCREWS (2)
Supplied with
Figure 5
Outlet Box
HANGER
BRACKET
NOTE: Ceiling cover, supply
wires and fan wires omitted
Figure 6
for clarity
If C4 Remote Control (optional) is desired, a Remote Receiver Unit must be installed (after setting the code) in
the Hanger Bracket prior to wiring your ceiling fan. See page 8

How to Hang Your Ceiling Fan

No
less than
7 ft
OUTLET BOX
TAB
OUTLET BOX
DOWNROD/HANGER
BALL ASSEMBLY
INSTALLATION NOTE
The fan must be hung with at least 7' of clearance
from floor to blades (Figure 4)
The outlet box must be securely anchored and
capable of withstanding a load of at least 50 lbs.
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may
result in damage to the fan blades.
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wallboard until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
1. Place the rubber pads on the ceiling side of the
Hanger Bracket (Figure 5).
2. Securely attach the hanger bracket to the outlet
box using the outlet box screws and washers
supplied with your fan or outlet box (Figure 5).
NOTE: Outlet box screws pass through slotted holes of
the hanger bracket (Figure 5).
3. Pull the electric wires in the outlet box down
through the opening in the hanger bracket and
bend wires up and out of the way so that the
hanger ball will easily fit into the hanger bracket.
4. Carefully lift the fan and seat the downrod/hanger
ball assembly on the hanger bracket that was just
attached to the outlet box (Figure 6). Be sure
the groove in the ball is lined up with tab on the
hanger bracket (Figure 5).
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
To avoid possible shock, do not pinch wires between
the downrod/hanger ball assembly and the hanger
bracket.
5
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING

Advertisement

Table of Contents
loading

Table of Contents