Table of Contents
Advertisement
Then, reattach the Reed Switch Bracket (54) and slide
the Reed Switch (56) slightly closer to or away from
the Magnet (137). Plug in the power cord and rock the
Pulley (73) forward and backward so that the Magnet
passes the Reed Switch repeatedly. Repeat these
actions until the console displays correct feedback.
When the reed switch is correctly adjusted, remove
the Reed Switch Bracket (54), retighten the two M4
x 10mm Clamp Screws (126), and reattach the Reed
Switch Bracket.
Then, reattach the outer disc to the right outer shield
and plug in the power cord.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted. To adjust the drive belt,
first unplug the power cord.
All manuals and user guides at all-guides.com
Next, see EXPLODED DRAWING B. Remove the
M4 x 16mm Screw (98), and then remove the Access
Cover (24) from the Right Inner Shield (21).
Then, tighten the M10 x 80mm Screw (131) until the
Drive Belt (72) is tight.
When you have properly adjusted the drive belt, reat-
tach the access cover to the right inner shield.
29
131
Advertisement
Table of Contents
