Jump-Starting - BMW Motorrad S 1000 RR Rider's Manual

with two-up riding package
Lubricate grommets 1 if ne-
cessary.
Engage tail section 2 in grom-
mets 1.
Install screw 3.
with two-up riding package
Install the passenger seat.
( 81)
Install the tail-hump cover.
( 81)
Install the rider's seat. (

JUMP-STARTING

CAUTION
Touching live parts of the
ignition system when the
engine is running
Electric shock
Do not touch parts of the
ignition system when the
engine is running.
OE
ATTENTION
Contact between crocodile
clips of jump leads and
vehicle
Risk of short-circuit
Use jump leads fitted with
fully insulated crocodile clips
at both ends.
ATTENTION
Jump-starting with a voltage
greater than 12 V
Damage to the on-board
OE
electronics
Make sure that the battery
of the donor vehicle does
not exceed a voltage of
82)
12 V.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
When jump-starting the en-
gine, do not disconnect the
battery from the on-board
electrical system.
Remove the front seat.
( 82)
Run the engine of the donor
vehicle during jump-starting.
Begin by connecting one end
of the red jump lead to the
positive terminal of the dis-
charged battery and the other
225