Jump-Starting - BMW Motorrad R 1250 RT special vehicle 2018 Rider's Manual

Table of Contents

Advertisement

Waveguide rings,
8
replacing
with daytime riding light
176
with Headlight Pro
Waveguide rings are integrated
into the headlight and can be
replaced only together with the
headlight. Consult a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
Replacing the LED
additional headlights
z
with additional headlight
The LED additional headlights
can only be replaced in full; it is
not possible to replace individual
LEDs.
Consult a specialist workshop,
preferably an authorised
BMW Motorrad dealer.

Jump-starting

ATTENTION
OE
OE
Excessive current flowing
when the motorcycle is
jump-started
Wiring smoulders/ignites or dam-
age to the on-board electronics
If the motorcycle has to be
jump-started connect the leads
to the battery terminals; never
attempt to jump-start the en-
gine by connecting leads to the
on-board socket.
OE
ATTENTION
Contact between crocodile
clips of jump leads and
vehicle
Risk of short-circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
greater than 12 V
Damage to the on-board elec-
tronics
Make sure that the battery of
the donor vehicle has a voltage
rating of 12 V.
Place the motorcycle on its
stand on firm, even ground.
Removing battery cover
(
179).
When jump-starting the engine,
do not disconnect the battery
from the on-board electrical
system.

Advertisement

Table of Contents
loading

Table of Contents