Related Manuals for SKF 85250
Summary of Contents for SKF 85250
- Page 1 User and maintenance instructions Air operated ejector Models and Date of issue July Form number Version ...
-
Page 2: Table Of Contents
Contents Declaration of Incorporation* .. U.K. Declaration of Incorporation* . . . Signal words for safety ... . . Safety ......... -
Page 3: Declaration Of Incorporation
N. Hanley Road St. Louis, MO U.S.A. TEL: + () - FAX: + () - Authorized to compile the technical file: SKF Lubrication Systems Germany GmbH Heinrich-Hertz-Straße - Walldorf, Germany TEL: + () - EMAIL: robert.collins@skf.com WEBSITE: www.skf.com... - Page 4 Lincoln Industrial Corporation N. Hanley Road St. Louis, MO U.S.A. TEL: + () - FAX: + () - Authorized to compile the technical file: SKF (U.K.) Limited Canada Close Banbury, Oxfordshire, OX RT, GBR EMAIL: robert.collins@skf.com WEBSITE: www.skf.com This U.K.
-
Page 5: Safety
Explanation of signal Safety words for safety Read and carefully observe these installation instructions before installing/operating/ troubleshooting the assembly. The assembly must be installed, maintained and repaired NOTE exclusively by persons familiar with the Emphasizes useful hints and instructions. recommendations as well as Install the assembly only after safety information to prevent property damage instructions and this guide have been read... -
Page 6: Owner/Operator Manual
Owner/operator Model 85250: Used with EPDM compatible WARNING materials. manual Always read and follow the fluid and Model 85252: Used specifically with solvent manufacturer’s recommenda- petroleum based materials. tions regarding the use of protective It is the responsibility of the Owner/Operator clothing and equipment. -
Page 7: Service And Disassembly Procedure
Service and Disassembly of wetted components disassembly procedure Remove the packing nut and gasket ( and ). Remove the bottom plate (). WARNING Remove the packing retainer and Always disconnect air supply to ejector u-cup ( and ). and relieve pressure before checking, ... - Page 8 Fig. Title heading in NPTF Air inlet Torque to 50 - 55 in.lbf (5.6 - 6.2 Nm) 1 Torque to 85 - 95 in.lbf (9.6 to 10.7 Nm) in NPTF Air inlet Torque to 90 - 100 Ft. Lbs. 20.1 20.2 in NPTF...
-
Page 9: Adjustment Procedure
NOTE Service parts A in ( mm) Iength of Item Description Part number Quantity (. mm) l.D. hose must be used at the material inlet to prevent hydraulic lock Bolt which may occur if rigid pipings used. ... - Page 10 Fig. Fig. Title heading Title heading (98 mm) 1 in (25.4 mm) (63.5 mm) (32 mm) (175 mm) /16 in in (7 mm) (75 mm) slots for (11 mm) mounting (349 mm) ...
- Page 11 This page left intentionally blank. ...
-
Page 12: Warranty
® SKF and Lincoln are registered trademarks of the SKF Group. © SKF Group The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permission is granted. Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss or damage whether direct, indirect or consequential arising out of the use of the information contained herein.
Need help?
Do you have a question about the 85250 and is the answer not in the manual?
Questions and answers