Bosch APC-AMC2-4R4CF Installation Manual page 12

12 en | Introduction
Notice!
The AMC2-4WE has no display. The information about the input and outputs will be shown on
special pages of the AMC2 display.
As the extension modules contain neither memory nor display they are controlled and
monitored entirely by the AMC2-4W.
The AMC2-4W can have an additional interface extension module AMC2-4WE, so that the
number of inputs and outputs can grow up to 64.
Notice!
An AMC2-4WE provides signals only to the AMC2 to which it is connected. Signal transfer to
another AMC2 is not possible.
The signal settings and parametrization of the readers connected to the extension module, are
carried out by the configuration applications in the access control system and by the
AMC2-4W to which it belongs.
The AMC2-4R4 standalone board (hereafter also referred as AMC2 or controller) are deployed
via a dedicated OPC-Server. Though similar in appearance to the AMC2-4W and AMC2-4R4
controllers, the AMC2-4R4 has no reader interfaces, but is intended instead for the efficient
monitoring and control of many devices, especially entrances, simultaneously. It is not an
extension board like the AMC2-16IOE, AMC2-8IOE, and AMC2-16IE but possesses its own CPU
and host interfaces.
The AMC2-4R4 has 16 analog inputs and 16 relay outputs. Via its inputs the module can
determine the status (e.g. locked, closed or open) of entrances, windows or other devices,
and its output signals can lock/unlock doors, or trigger alarms with external monitoring
systems in the case of an intrusion.
If the 8 and the 8 outputs are insufficient for your needs, then up to three extensions
(AMC2-16IOE , AMC2-8IOE, or AMC2-16IE) can be connected, thus providing the AMC2-4R4
with a maximum of 64 inputs and 64 outputs for configuration.
The AMC2 has eight analog input devices and eight relay outputs. With its analog input
devices, the AMC2 verifies, for example, if a lock is closed or open. The relay outputs can be
used to activate lock mechanisms if access is granted, or activate an external alarm system if
an intrusion or system alert is detected.
If the eight inputs and eight outputs of the AMC2 are not enough to configure the system up to
three additional extensions AMC2-16IOE can be connected. The extension offers 16 additional
inputs and outputs.
The AMC2-16IOE electronic is completely covered by a plastic housing.
Notice!
The AMC2-16IOE has no display. The information about the input and outputs will be shown
on special pages of the AMC2 display.
The AMC2-16IOE contains 16 analog inputs and 16 relay outputs. In analogy with the AMC2 it
verifies if a lock is open or closed respectively activates alarms or lock mechanisms.
An AMC2-4W can have an additional interface extension module AMC2-4WE, so that the
number of inputs and outputs grow up to 64.
2020-01 | V02 | Installation manual
Access Modular Controller 2
Bosch Access Systems V.B.