(Electric Models Only) - Maytag MGD6500MBK Technical Manual

b. Remove the hex-head screw, unhook the end of the bracket, and remove
the TCO.
A. Clip
REMOVING THE THERMAL CUTOFF (TCO),
HEATER, AND HIGH-LIMIT THERMOSTAT

(ELECTRIC MODELS ONLY)

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug dryer or disconnect power.
2. Remove the rear panel (see
3. To remove the Thermal Cutoff (TCO):
a. Remove the two wires from the TCO terminals.
40
FOR SERVICE TECHNICIAN'S USE ONLY
A
B
B. Hex-Head Screw
page 39 for the procedure).
b. Remove the hex-head screw, unhook the end of the bracket, and remove
the TCO.
4. To remove the Heater and High-Limit thermostat.
a. Lift the locking tab and remove the wire connector from the High-Limit
Thermostat.
b. Remove the wire connector from the heater terminal block.
A.High-Limit Thermostat B. Heater Block
Remove the two hex-head screws from the heater assembly
c.
(see Figure A) and remove the assembly (see Figure B).
A
B
Figure A