Service Test Mode Chart - Maytag MGD6500MBK Technical Manual

SERVICE TEST MODE CHART

Step#
1 User enters Service test mode through
Service Diagnostics by pressing
releasing the 2
sequence
2 Press and release START button to
begin the test
3 All LEDs ON
4 Single Button Actuation test
dz Press and release TEMPERATURE
button.
5 Heater/gas valve test
1. Press and release TEMPERATURE
button.
2. After the TEMPERATURE button is
pressed, the heater or gas valve will
be turned OFF.
6 Door test
1. Open the door.
2. After door is opened all loads will be
turned OFF. Drum light will be turned
ON.
7 Moisture strips
dz User touches the front moisture
strips for 5 seconds.
8 Service test finishes
NOTE: Electric dryer performance is optimized for 2-phase, 240 VAC service. If complaint is made regarding electric dryer performance and the
L1 to L2 voltage is ~208 VAC, dryer may be connected to a 3-phase service with reduced wattage that will decrease dryer performance.
If a fault is detected at anytime in the test cycle, the service test cycle will stop and display the corresponding error code.
FOR SERVICE TECHNICIAN'S USE ONLY
Action
Door must be closed
button used in entry
nd
Motor ON
Heater /gas valve ON
Water valve On (Steam models
only)
Motor ON
Heater /gas valve ON
Water valve On (Steam models
only)
Motor ON
Heater /gas valve ON
Water valve On (Steam models
only)
Motor ON
Heater /gas valve ON
Water valve On (Steam models
only)
Motor ON
Water valve ON (Steam
models only)
Door open
-
Component
All LEDs are OFF and machine is waiting for START
button to be pressed.
-
1. All LEDs are ON.
1. All indicators are ON at HMI and machine is waiting
for the TEMPERATURE button to be pressed.
2. After the TEMPERATURE button is pressed, all
indicators in the HMI are turned OFF.
1. The SENSING indicators is turnd ON at HMI and
machine is waiting for the TEMPERATURE button to
be pressed.
2. After the TEMPERATURE button is pressed the WET
indicators is turned ON.
1. The SENSING and WET indicators are turned ON at
HMI and the machine is waiting for the user to open
the door.
2. After the door is opened, the COOL indicator is turned
ON.
1. The SENSING and WET and COOL indicators are
turned ON at HMI and the machine is waiting for the
user to touch the moisture strips.
If all sequence is completed the HMI will turn ON Sense,
Wet , Cool, Done, 90, 60, 30, and 15 minutes
indicators and the end of cycle sound is played.
User Interface Response
13