Table of Contents
Advertisement
100
Audi
side assist
- Improper reliance on the side assist sys-
tem can cause collisions and serious
personal injury:
- Never rely only on side assist when
changing lanes.
- Always check rear view mirrors to make
sure that it is safe to change lanes.
- Side assist cannot detect all vehicles un-
der all conditions- danger of accident!
- Please note that side assist indicates
there are approaching vehicles, or
vehicles in your blind spot, only after
your vehicle has reached a driving speed
of at least 19 mph (30 km/h).
- In certain situations, the system may not
function or its function may be limited.
For example:
- if veh icles are approaching or being left
behind very quickly . The display may
not turn on in time.
- in poor weather conditions such as
heavy rain, snow or heavy mist .
- on very wide lanes, in tight curves or if
there is a rise in the road surface.
Vehicles in the adjacent lane may not
be detected because they are outside
of the sensor range .
(D
Note
The sensors can be displaced by impacts or
damage to the bumper, wheel housing and
underbody. This can affect the system.
Have your authorized Audi dealer or au-
thorized Audi Service Facility check their
function.
@
Tips
- If the window glass in the driver's door
or front passenger's door has been tint-
ed, the display in the exterior mirror may
be misinterpreted.
- For Declaration of Compliance to United
States FCC and Industry Canada regula-
tions¢
page 288.
Activating and deactivating
Applies to vehicles: rnit side assist
Fig. 106 Dri ver's door: Side assist butto n
.. Press the button
c>
A
in General informa-
tion on page 99
to switch the system on/off .
The LED in the button turns on when side
assist is switched on .
Adjusting the display brightness
Applies to vehicles: wit h side assist
The brightness setting can
be
adjusted via the
MMI.
.. Select:
!CAR I
function button> (Car)* sys-
tems
control button
>
Driver assist
>
Audi
side assist.
The display brightness adjusts automatically
to the brightness of the surroundings, both in
the information and in the warning stage. In
very dark or very bright surroundings, the dis-
play is already set to the minimum or maxi-
mum level by the automatic adjustment . In
such cases, you may notice no change when
adjusting the brightness, or the change may
only be noticeable once the surroundings
change.
Adjust the brightness to a level where the dis-
play in the informa tion stage will not disrupt
yo ur view forward. If you change the bright-
ness, the display in the exterior mirror will
briefly show the brightness level in the infor-
mation stage. The brightness of the warning
stage is linked to the brightness in the infor-
mation stage and is adjusted along with the
information stage adjustment .
Advertisement
Table of Contents
