Audi A7 Sportback 2014 Owner's Manual page 27

Instruments and warning/indicator lights 25
For some vehicle functions, you can access the
trip information from the temporary memory
¢ page 26 in the line CD¢ fig. 5.
.&_
WARNING
-
- Never rely exclusively on the outside
temperature display to determine if a
road surface is icy or not . Keep in mind
that road surfaces, especially bridges
and overpasses, could be ice covered and
slippery even at an outside temperature
above 41 °F (+5 °().
- Always remember, even if the "snow-
flake" symbol (ice warning) does not ap-
pear in the display, black ice could be on
the road.
- Always reduce your speed and drive with
special care in cold weather conditions
when the chance of encountering icy
road surfaces increases.
@
Tips
- At temperatures below 14 °F
(+
5 °C) a
snowflake symbol appears ahead of the
temperature display. It is intended to re-
mind the driver to pay special attention
to
ice on the road
¢ ,&.. If the vehicle is
stationary, or if you are driving at a very
low speed, the temperature shown in the
display might be slightly higher than the
actual outside temperature . This is
caused by the heat being radiated from
the engine .
- You can select the units used for temper-
ature, speed and other measurements in
the MMI.
- For information on the audio/video and
navigation* functions, refer to the sepa-
rate MMI owner's manual.
Operation
The driver information system is operated us-
ing the buttons on the multifunction steering
wheel.
Fig. 6 Multif unctio n st eering wh eel: operat i ng t he driv-
er informat ion syst em
Fig. 7 Driver informat ion system : openin g t he vehicle
functio ns menu
Operating concept
"'Switch the ignition on .
"'To switch between the tabs, press the rocker
switch CD to the left or right ¢ fig. 6.
"'To access additional information below or
above, rotate the thumbwheel @ down or
up.
"' To confirm a selection, press the thumb-
wheel @ .
"' Press the
Iii
button @ to open a sub menu
for an active tab .
"'Press the button @ to access a function for
the programmable steering wheel button* .
Accessing Vehicle functions
"'Select the first tab with the rocker switch
CD-
.. Press the button
liJ @.
The
Vehicle func-
tions
menu appears ¢ fig. 7 .
"'To select a menu item, turn and press the
thumbwheel @ .