Table of Contents
Advertisement
Instruments
and warning/indicator
lights
19
II!
Engine start system fault. Please con-
tact dealer
If the ind icator light turns on and the mes-
sage appears, there is a ma lfunction in the en-
gine start system.
Drive to your authorized Audi dealer immedi-
ately to have the malfunction corrected.
~
Air suspension
Appl ies to vehicles: with air suspension
•
Air suspension: system fault. Can contin-
ue slowly with max. 35 mph .
There is a malfunct ion that can result in re-
stricted dr iving stab ilit y.
Carefully drive at a maximum speed of 35
mph (60 km/h) to your authorized Audi dealer
or qualified workshop to have the malfunction
cor rected.
•
Air suspension: service mode. Vehicle
can only be moved with restrictions
Carefully drive to your authorized Audi dealer
or qualified workshop immediately to have
the service mode deact ivated .
II
Air suspension fault
There is a system ma lfunction that can result
in restricted driving stability or reduced
ground clearance.
Drive to your auth orized Audi dealer immedi-
ately to have the malfunction corrected .
II
Air suspension: vehicle too low. Ground
clearance reduced
The ground clearance is very low due to a sys-
tem malfunct ion . Wait until the air suspen-
sion system has restored normal ground clear-
ance. Otherwise, conditions such as an uneven
road surface can lead to vehicle damage.
G:;/ !f
Safety systems
The
fl
(USA
models);EI
(Canada models) in-
dicator light monitors the safety systems (e.g.
airbags, pretensioners) and illuminates for a
few seconds each time you switch the ignition
on .
If the
fl
(USA
models);EI
(Canada models)
indicator light does not go out , or if it illumi-
nates while you are driving, or if it starts to
blink, then there is a malfunction somewhere
in the system. If the light does not ill um inate
when you switch the ign ition on, th is also
means there is a malfunct ion.
A
WARNING
If you have a malfunction in the safety sys-
tems, contact your authorized Audi dealer
immediately. Otherwise the safety sys-
tems may not work properly in an acci-
dent.
&
Central indicator light
If the indicator light.
or
n
tu rns on, check
the message in the instrument cluster .
nl ft
Electronic Stabilization
Control
(ESC)
If the
JjJ
indicator light blinks wh ile driving,
the ESC or ASR (Anti-Slip Regulation) is active -
ly regulating.
If the
$.J
indicator li ght turns on, the system
has switched the ESC off. In this case, you can
switch the ign ition off and then on to switch
the ESC on again. The ind icator light turns off
when the system is functioning fu lly.
If the
1B
indicator light turns on, ESC was re-
stricted using the
1 .$
OFF I
button
c>
page
196.
Stabilization control (ESC/ABS): Fault! See
owner's manual
If the
G)
indicator light and the ABS indicator
light
fJ]
(USA mode ls)
;flJ
(Canada models)
turn on and the message appears, the ABS or
electronic differential lock is malfunctioning.
This also causes the ESC to malfunction . The
brakes still function with their normal power,
but ABS is not active .
liJI,
Advertisement
Table of Contents
