Audi A7 Sportback 2014 Owner's Manual page 131

@
Tips
To open the garage door, press the button,
but do not press it for longer ten seconds
or the Homelink module will switch to
programming mode .
Programming the transmitter
Applies to vehicles : with Home Link
Fig. 147 Distance betwe en t he radiato r grille and t he
hand t ransmi tter
You can program the fixed code and rolling
code systems using the described procedure.
Programming the button
.. Turn the ignition on .
.. There are two ways to program a button :
press the button that you would like to pro-
gram . The MMI will display instructions to
guide you through the programming . Or
.. Select :
I CARI
function button> (Car)* sys-
tems control button > Vehicle settings >
Garage door opener > Program garage door
opener .
.. Select the button that you would like to pro-
gram .
.. Follow the instructions in the MMI.
.. If the garage door opening must also be
synchronized with the Homelink module,
refer to the owner's manual for the garage
door opener.
Remote cont rol units for garage door openers
in Canada are set to stop transmitting radio
frequency signals after two seconds . This time
may not be sufficient for the Homelink sys-
tem to learn the radio frequency signal. Per -
form all other steps as described above .
Homelink 129
Erasing/Clearing the programmed button
settings
.. To erase all of the programmed buttons at
the same time, select:
!CAR !
function button
> (Car)* systems function key> Vehicle set-
tings
>
Garage door opener
>
Clear pro-
gram settings> Yes. The programmed but -
tons can not be erased individually . Repro-
gram the buttons if necessary .
.. Reprogram an individual button in the same
manner that you would for the one-time
programming.
Displaying the version/status/country
code
.. Select:
!CAR I
function button> (Car)* sys-
tems control button > Vehicle settings >
Garage door opener> Version information.
(D
Tips
- The required distance between the hand
transmitter and the Homelink module in
the radiator grille ~ fig. 147 depends on
the system that you are programming .
- Depending on the model of the garage
door opener, you may need to release the
button on the remote and press it again
when programming. When program-
ming a new device, keep the button
pressed for at least 15 seconds before
trying again with the transmitter in a dif-
ferent position. Watch out for the emer-
gency flasher during that time.