Labels On The Product - R&S QPS Walk2000 Getting Started

®
R&S QPS Walk2000
Take the following measures for your safety:
●
Before switching on the product, ensure that the voltage and frequency indicated
on the product match the available power source. If the power adapter does not
adjust automatically, set the correct value and check the rating of the fuse.
●
If a product has an exchangeable fuse, its type and characteristics are indicated
next to the fuse holder. Before changing the fuse, switch off the product and dis-
connect it from the power source. How to change the fuse is described in the prod-
uct documentation.
●
Only use the power cable delivered with the product. It complies with country-spe-
cific safety requirements. Only insert the plug into an outlet with protective conduc-
tor terminal.
●
Only use intact cables and route them carefully so that they cannot be damaged.
Check the power cables regularly to ensure that they are undamaged. Also ensure
that nobody can trip over loose cables.
●
If the product needs an external power supply, use the power supply that is deliv-
ered with the product or that is recommended in the product documentation or a
power supply that conforms to the country-specific regulations.
●
Only connect the product to a power source with a fuse protection of maximum
20 A.
●
Ensure that you can disconnect the product from the power source at any time.
Pull the power plug to disconnect the product. The power plug must be easily
accessible. If the product is integrated into a system that does not meet these
requirements, provide an easily accessible circuit breaker at the system level.
Meaning of safety labels
Safety labels on the product warn against potential hazards.

1.2 Labels on the product

Labels on the casing inform about:
●
Personal safety, see
●
Product and environment safety, see
●
Identification of the product, see
Getting Started 1179.5782.02 ─ 03
Potential hazard
Read the product documentation to avoid personal injury or product damage.
"Meaning of safety labels"
Safety and regulatory information
on page 7
Table 1-1
Chapter 4.10, "Device
Labels on the product
ID", on page 18.
7