Inserting The Ecl Card - Danfoss ECL Comfort 300 User Manual

15a

Inserting the ECL Card

How to insert your ECL Card the first time
After the power has been switched on, open the lid on the
front side of the controller.
Place the ECL Card with the yellow side facing you. This
enables the controller to read the ECL Card data. The
controller immediately starts to copy the application type and
factory settings from the ECL Card. After copying, the display
will show you the application type. After approx. 10 sec. the
display will change to display line C.
Display example:
C P Y
0
C 7 3
Software
05
version, ECL
Card
Line
C
Circuit 1 8 3
Time
3
Outdoor
temp.
0 3 6 9 12
The controller is now ready to be set to control your system.
If the display keeps showing CPY, see section 34b.
The grey
side of the
ECL Card
C 9 9
Application type
Software version,
109
controller
5
2 0 Desired room temp.
15 18 21 24
Understanding the ECL Card
The ECL Card contains factory settings for a standard
system. If the actual system differs from the standard
system, the controller must be adjusted accordingly. After
the adjustment, the new settings should be stored on the
ECL Card.
For ECL Card copying and daily use including adjustment
of temperatures and schedules, insert the ECL Card with
the yellow side facing you.
For system set-up adjustments, the grey side of the ECL
Card - the installer's side - must be facing you.
As a main rule, the ECL Card should always remain in the
controller during service, maintenance and setting.
If the card is removed or left in the controller with the grey
side facing you, please note that:
• After approx. 25 min.:
- The controller cannot be operated.
- The controller reverts to display C (section 1).
• The ECL Card must not be exposed to direct heat or
sunshine.
If several controllers are installed in the system you can
write a title on the ECL Card with a permanent ink pen.
Do not remove the ECL Card while copying. The data on the
ECL Card can be damaged!
When you store your personal settings on your ECL Card, the
factory settings will be overridden.
15b
The grey
side of the
ECL Card