Danfoss ECL Comfort 300 User Manual page 18

6a
Hot points
The time shown in the display is one hour off?
See the summer time changeover in line 198, section 32.
The time shown in the display is not correct?
The internal clock may have been reset, if there has been a
power break for more than 12 hours.
Set time and date.
See section 17.
The ECL Card is lost?
Switch the power off and on again to see the
system type and the software generation of the controller.
Order a replacement from your Danfoss representative.
Insert the new ECL Card with the yellow side facing you and
make sure that you copy your personal settings from the
controller to the ECL Card.
See section 34.
The room temperature is too low?
Make sure that the radiator thermostats do not limit the room
temperature.
If you still cannot obtain the desired room temperature by
adjusting the radiator thermostats, the flow temperature
is too low. Increase the desired room temperature (section
3). If this does not help, adjust the heat curve / balance
temperature (section 20).
The room temperature is too high during setback
periods?
Make sure that the min. flow temperature limitation is not too
high. See section 22.
The temperature is unstable?
Check that the flow temperature sensor is correctly
connected and in the right place. Adjust the control
parameters (section 26).
If the controller has a room temperature signal, see section
23.
The controller does not operate and the control
valve is closed?
Check that the flow temperature sensor is measuring the
correct value, see section 1.
Check the influence from other measured temperatures.
How to make an extra comfort period in the
schedule?
You can make an additional comfort period by pushing the
shift and + buttons simultaneously for 2 seconds.
See section 4.
How to remove a comfort period in the schedule?
You can remove a comfort period by pushing the shift and -
buttons simultaneously for 2 seconds.
See section 4.
How to restore your personal settings?
Insert the ECL Card with the yellow side facing you. Go to line
9 (is not displayed), which is the second line below line 7.
Select copy direction 'card to controller' (left to right) by using
the shift button. Push the + button to copy.
See section 5.
This is a collection of frequently asked questions for the ECL
Comfort 200 as well as ECL Comfort 300 series. Consequently,
you might come across some questions that do not apply to your
application.
6b