Omntec Proteus Series System Programming Manual page 2

1. POWERING ON
For installation instructions, refer
to document DI00008 (Mini-Me™
Installation Manual).
An appropriate communications
connection is required to connect
an MMRD7 (Mini-Me) to a
PROTEUS® controller, or any
other industry-standard ATG.
PROTEUS communications can be
either RS-232, RS-485, or
Ethernet connections.
It is necessary to check the communications settings (e.g.: baud rate) of both devices to
establish proper communications. The MMRD7 communication mode must be set to either
TRANSMITTER or RECEIVER mode based on the function of the controller.
When the MMRD7 is powered on and not connected to an ATG, the display will show
incorrect time and date, a **NO RESPONSE** status, and disabled tanks.
(See Figure 1.0)
After connecting and establishing
communication to an ATG, the
MMRD7 will update its
information and mirror the ATG.
(See Figure 2.0)
Document No.: DOC00011_A.docx
Revision Date: 11-30-2023
Figure 1.0
Figure 2.0
www.OMNTEC.com
Page 2 of 8