Omntec PROTEUS Mini-Me RD7CTS Programming Instructions

RD7CTS Remote Display
1. Powering On
For installation instructions, refer to
document DI00028 (PROTEUS RD7CTS
Installation Instructions).
If plugging into an OMNTEC OEL8000II's RS‐
232 port, make sure it is connected to
COMM2 or COMM3 of the motherboard
and set for Remote Mode.
When the RD7CTS is powered on and not
connected to an ATG, the display will show
the screen below. (See Figure 1.0)
After connecting to an ATG, the RD7CTS will
update its information to show the correct
time and date as well as Inventory. (See
Figure 2.0)
Figure 1.0
Figure 2.0
OMNTEC Mfg., Inc., 2420 Pond Road, Ronkonkoma, NY 11779
Phone (631) 981‐2001 Fax (631) 981‐2007 www.OMNTEC.com
File Name: DP00028 rev2050.docx Page 1 of 2 Rev Date: 12‐10‐2020
2. Navigating to Setup
From the System Status Menu, press HELP
MENU. (See Figure 3.0)
In HELP MENU press SETUP. Default
password is "000000" (See Figure 4.0)
Below is the SETUP MENU. (See Figure 5.0)
Programming Instructions
Figure 3.0
Figure 4.0
Figure 5.0