Configuration Settings Via Webaccess/Dmp; Restoring And Backing Up The Router Configuration - Advantech UCR11 v2 Start Manual

2. Configuration Settings via WebAccess/DMP
Your router has been pre-installed with the WebAccess/DMP client, which has activated
the connection to the WebAccess/DMP server by default. You can disable this connection on
the Welcome page when logging into the router's web interface or on the (Customization ->
Router Apps -> WebAccess/DMP Client) configuration page. For more information see the
configuration manual of your router, chapter Basic Information -> WebAccess/DMP Configu-
ration.
The activated client periodically uploads router identifiers and configuration to the Web-
Access/DMP server.
4. Restoring and Backing up the Router Configuration
The default factory settings will replace the current configuration if you reset the router.
Therefore, we recommend you back up the router configuration before resetting the device.
Refer to the configuration manual for more information.
You can restore the default router configuration once the router boots up and the PWR
LED starts blinking. To do so, press the RST button on the router's front panel for more than
4 seconds. After you press this button, all settings reset to the default values, and the router
will reboot.
After logging on to the device for the first time, we strongly recommend changing the
default password due to security reasons. Simultaneously, you will gain access to all
functions of the router.
For security reasons, we highly recommend updating the router's firmware to the latest
version regularly. Downgrading the firmware to an older version than the production
version or uploading firmware intended for a different device may cause the device's
malfunction.
QSG-0001-EN, October 5, 2022 6 Released in the Czech Republic
Start Guide