Panasonic Omnivision PV-V4620 Operating Instructions Manual page 5

Between ANT. and VCR
• Case 1: Twin Lead Cable Only
To VCR Terminal
From Antenna _
300-75 ohm
(Flat) Twin Lead Transformer
300 Ohm Cable (not supplied)
• Case 2: Twin Lead & Coaxial Cables
UHF/VHF Band Mixer_j
/I
(not
(Round) 75 Ohm
coaxial Cable
To VCR Terminal
• Case 3: Two Twin Lead Cables
)U'HFNHF Band Mixer_ _
Transformer
II
(not supplied)
To VCR Terminal
• If your TV has both post and plug-type
VHF terminals, the post connection is
recommended to minimize signal loss.
Note to CABLE system installer:
attention to Article 820-40 ot the NEC inUSA _and to the Canadian
This reminder is provided to cal_ the CABLE system instal_er's
I Electrical Code in Canada) that provides guidelines for proper
!rounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to
he point of cable entry as practical
Between VCR and TV
f
• Case 1 : Screw & Plug Type Terminal
UHF/VHF Band
TV
Separator
(not supplied)
BF Coaxial Cable
• Case 2: Screw Type Terminal
TV
75-300 ohm
Transfm'mer I ,_ _ I
(not ,upp 7 I-V,orF
• Case 3: Double Screw Type Terminal
UHFNHF Band
TV
Separator
(not s_VHF
• Case 4: Complex TV TermLnal
TERMINALS ON BACK OF TV SET
Split out _
ANT1 (_
ANT2
• Connect to one of the ANT terminalsand
select the same antenna number on the TV+
[-FCC Warning:Any unauthorizedchanges or modifications ]
I to this equipmentwould void the user's euthodtyto operate.
I
5