Panasonic Omnivision PV-V4620 Operating Instructions Manual page 4

Congratulations
on your purchase of one of the most sophisticated and
reliable products on the market today. Used properly,
it will bring you and your family years of enjoyment,
Please fill in the information below. The serial number
is on the tag located on the back of your VCR.
• Date of Purchase
• Dealer Purchased From
• Dealer Address
• Dealer Phone No.
• Model No.
• Serial No.
[] RemoteControl
LSSQ0204
[] Batteries 2 "AA"
@QQ
Fo " o
_ m _2
[] RF Coaxial Cable
VJAS0196
To order accessories, call toll free
1-800-332-5368.
1) Open the cover.
,Inse_ the
batteries as
marked.
3) Close the cover.
[] Battery replacement caution
• Do not mix old and new batteries.
• Do not mix alkaline with manganese batteries.
4
If your TV has AUDIO and VIDEO IN terminals, connect
them to VCR for higher quality picture and sound.
You can enjoy stereo sound even if your TV is not stereo
by connecting a stereo amplifier to the VCR.
Connect VCR and TV with an AV Cab{e (not supplied) or a
RF Coaxial Cable (supplied) as shown in the figure below.
ANTENNA
(See page 5)
f
_ _._ _ CABLE TV
i vC-
\
VCR
OUTDOOR ANTENNA INDOOR ANTENNA
o r %
J
Disconnect antenna or cable from TV and
connect to VCR.
AUtO IN FROM ANT.
°
/
a)AVCASLE'_ -I !
b) RF
(not supplied) 1_ OAxlAkCABLEV
IN _ _'_ UHF
t. R
ouTO 0 0..-
VIDEO_ /
TV Connect VCR
to TV with RF
Coaxial Cable,
1) While connection b) (above) is sufficient, connection
a) offers better sound and picture (especially with
this model , you can enjoy Hi-Fi STEREO sound).
2) For both connections a) and b) proceed as follows:
• To use VCR : VCR Power on, set TV to VIDEO.
• To watch TV : VCR Power off, select channel on.
3) Set VCR Output to channel 3 or 4 (not an active
station), (See page 6.)
Use the L Audio OUT jack for proper sound reproduction
when connecting to a monaural TV.
WARNING ]
When using "Nut type" RF coaxial cables, tighten with fingers
only. Overtightening may damage terminals.