Panasonic Omnivision PV-V4620 Operating Instructions Manual page 11

Connections you'll need to make.
Playing (Source) VCR
Recording (Editing) VCR TV for Monitoring
AUDIO
o
_R
© L
VIDEO G_
IN1
IN FROM ANT.
@
VHF/UHF
OUT TO TV
@
AUDIO
IN FROM ANT.
0 R (_ AUDIOIN
_V 2 L VHFIUHP VHF, 0
IDE OUT TO TV UHF VIDEOIN
t o ® o
OUT
or
VIDEOIN2 L_ONO.AUOIOI,2-R
Front of VCR O O O
1
Insert pre-recorded
tape.
t
2
3 and
4
PAUSE Put in Standby mode.
(_ Press PLAY, then
SLOW PAUSE/SLOW at starting
point.
Start dubbing.
Press PLAY.
Insert blank tape
with record tab.
Select LINE mode.
0_,%_ Press INPUT.
(See "Selecting the
Input Mode" below.)
REC PAUSE Put in Standby mode.
(_ and (_ Press REC, then
SLOW PAUSE/SLOW
immediately.
PAUSE Start dubbing.
Q Press PAUSE/SLOW.
SLOW
5
Stop dubbing.
Press STOP.
Stop dubbing.
Press STOP.
• To Monitor Dubbing on Your TV
1
Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2 Set the VCR/TV Selector on the Recording
VCR to "VCR."
Dubbing tapes protected with Copy Guard will have
poor quality results,
• Selecting the Input Mode
Method t: Press INPUT.
Channel Number <--> LINE1 <--> LINE2
Method2: Press CH _kJV, Display will change as below.
(_ (CABLE) (TV)_
"*'_LINE2,,t-_-LtNE1"0-_125 or 69 4-""
• "LI" or "L2" lights on Multi-Function Display
(about 4 sec.) when LINE1 or LINE2 is selected.
• LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
Caution:
Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.)
]]