Panasonic Omnivision PV-V4620 Operating Instructions Manual page 18

Manual VCR Plus+ System
Channel Setup
• Before you begin, complete "Channel Setup
Preparations" below right.
Imoortant Note
• If your VCR connection type changes from type A to B on
page 14, repeat steps 1-4 of page 15 and select VCR •
CABLE/DSS • TV before proceeding with these steps.
Do "Auto VCR Plus+ System Channel
Setup (Part 1)," steps 1-3 on page 16.
2
VCR Plus+ CH SET UP
AUTO SET
_ ra_[er.,r a [,.']_1
SELECT:& • KEY
SET :_ KEY
END :ACTION KEY
Select MANUAL SET.
1) Press &Y
_._i.. to select.
L2) Press •
to set.
3
IMPORTANT NOTE:
For step 3, use the list you prepared. You may leave
lines blank if you don't receive that station, or if the
GUIDE CH number and the RECEIVE CH numbers
are the same.
VCR Plus+ CH SET UP
GUIDE CH RECEIVE CH
02 --
SELECT:A • KEY
SET :_ KEY
END :ACTION KEY
VCR Plus+ CH SET UP
GUIDE CH RECEIVE CH
• 01 []
02 --
SELECT:A • KEY
SET :< KEY
END :ACTION KEY
Select VCR Plus+
channels.
i 1) Press •
,,_,_i to move
_ c ursor to
right
column.
2) Press AY to change
RECEIVE CH number.
3) Press • to set.
4) Press AY to scroll
up/down GUIDE CH
column.
• Repeat step 3 until list is
complete.
To make corrections,
Press Ay and • to move to error, then AY to change,
or ADD/DLT* to erase number.
4
End setup.
Press ACTION
three times.
I
• Make each entry within 5 minutes or the VCR will exit this mode
• Once local channels have been programmed, they will stay in
memory, even _n the case of a power failure.
)8
Process of Recording
iConnection 1
L
[Programming!
S
Q EJECT LIGHT
G>@®
_G_GD
Q_ (2_ QD
RE_ C,S_y T
Q C_ O
I:_) 0 0 0-[
2
SELECT/
• SET
J3 •
:PLAY
• :STOP
< :nEW
/ • :FF
J
,' 4
ACTION
ADD/ -- 3
DELETE
Channel Setup Preparations
In order to complete step 3 left, make a
local channel list (see example below),
You will need the following:
• A line up of normal TV and/or Cable stations and
the channel number you receive them on.
• A list of Guide (VCR Plus+) channel numbers for
the stations you receive found in TV Guide and
selected newspapers.
1 Make a 3-column chart. In the left column, write
the name of all the stations you receive.
2 In the middle column, write each station's Guide
(VCR Plus+) number from TV Guide.
3 In the right column, write the channel number
your TV receives the station on.
EXAMPLE ONLY
Broadcast or
Cable
Station Name
HBO
Nickelodeon
CBS
FOX
Assigned Channel no.
Guide your TV
(VCR Plus+) rsceivesthe
channel no. station on
33 15
38 2O
04 04
11