Table of Contents
Advertisement
SECTION 4: OPERATIONS
Media blasting presents a real hazard of silicosis and other lung contamination injuries! These
injuries are permanent and can get worse over time. If you use media blasting equipment
without the proper eye protection and respirator, your lungs and eyes may become irreversibly
contaminated. DO NOT use this blast cabinet unless you know how to use it, protect yourself
correctly, and keep all unprotected bystanders away. For the latest types of protective equipment
and acceptable respirator types, contact your local OSHA or NIOSH office.
To reduce your risk of
serious injury, read this
entire
using machine.
Damage to your eyes and lungs could result
from using this machine without proper pro-
tective gear. Always wear safety goggles and
a respirator when operating this machine.
NOTICE
If you have never used this type of equip-
ment before, WE STRONGLY RECOMMEND
that you read books, trade magazines, or
get formal training before beginning any
projects. Regardless of the content in this
section, Grizzly Industrial will not be held
liable for accidents caused by lack of train-
ing.
-20-
manual
BEFORE
Preparation
NEVER sand blast with the doors open,
point the gun at yourself or anyone else, or
attempt to service any part of this machine
while it is plugged in or connected to air
pressure. ALWAYS disconnect the blast
cabinet from power and air pressure when
not in use, or during maintenance or adjust-
ments. Ignoring this warning may lead to
severe injury.
To prepare for a typical media blasting
operation:
Conduct the daily-check of the cabinet.
1.
Select and install the required blast tip, load
2.
the media, and empty dust collector canister.
Empty the air supply water separators, connect
3.
power and air to the cabinet, and adjust the
regulator to the required air pressure.
Remove water, oil, grease, and loose paint
4.
or scale from the workpiece, then place the
workpiece into blast cabinet.
Put on your safety goggles and a respirator,
5.
and begin the media blasting operation.
Model G0708 (Mfd. Since 12/23)
Advertisement
Table of Contents
