Speakers - HP x360 330 G1 Maintenance And Service Manual

Speakers

Description
Speaker Kit (includes left and right speakers and cables)
Before removing the speakers, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the keyboard/top cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the WLAN module (see
7. Remove the system board (see
Remove the speakers:
1. Release the speaker cables from the retention clips (1) built into the base enclosure.
2. Remove the four Phillips PM2.0×5.8 shoulder screws (2) that secure the speakers to the base enclosure.
3. Remove the speakers (3).
NOTE:
of or damage to these isolators can cause degradation to speaker performance.
Reverse this procedure to install the speakers.
WLAN module on page
System board on page
When removing the speakers, make note of the location of the six rubber isolators (4). Removal
Keyboard/top cover on page
Battery on page
27).
29).
Spare part number
809838-001
21).
23).
Speakers 35