Qsan Technology XCubeSAN XS5224D Hardware Manual page 131

Press the attention button of flash module until the flash module status LED is blinking.

After blinking for a while, the LED will light off. At this point, you can safely remove the
flash module.
Figure 6-23 Pressing Attention Button of the Flash Module
Press the release button of flash module and pull it out until it is free from system

chassis.
 Install the substitute flash module. The detailed steps of installing the flash module,
please refer to the chapter 3.5,
Install the dummy cache-to-flash cage and then use a Phillips screw driver to tighten it.

Figure 6-24 The Procedure of Removing the Flash Module from the System Chassis
The following content and image are detail steps of removing the power module.
Installing the Optional Cache-to-Flash Modules section.
111
Quick Maintenance