Table of Contents
Advertisement
Use one hand to hold one end of the controller module (the side with release levers) and
the other hand hold the bottom of the controller; pull out the controller module until it is
free from the system chassis.
Figure 6-4
Installing the Controller Module
The following content and images are the detail steps of installing the controller module
into the system chassis.
Make sure the position of both release levers of the controller is at downward.
Align and place the controller to the empty controller slot.
Push the controller module all the way into the controller slot until the position of two
release levers move upward automatically.
Pull up both release leavers at the same time until they totally parallel with the controller
cage and then use a Phillips screw driver to tighten both screws.
98
©
Copyright 2021 QSAN Technology, Inc. All Right Reserved.
Procedures of Removing the Controller Module
Advertisement
Table of Contents
