Subscribe to Our Youtube Channel
Related Manuals for Mooreco 90449 Series
Summary of Contents for Mooreco 90449 Series
- Page 1 Modular Teacher Desk - Double Pedestal Part Numbers: 90449-XXXX-XX / 90450-XXXX-XX ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE ENSEMBLAJE INSTRUCTIONS DE MONTAGE DO NOT THROW AWAY! NO LA TIRE NE PAS JETER UPDATED AS OF: 09/04/2019 1 of 9...
- Page 2 Parts 90369 - Pedestal 58590 - Support Tube 58259 (72”)/ 58258 (60”) - Modesty Panel Table Top (Custom) ASSEMBLY INSTRUCTIONS DO NOT THROW AWAY! INSTRUCCIONES DE ENSEMBLAJE NO LA TIRE INSTRUCTIONS DE MONTAGE NE PAS JETER UPDATED AS OF: 09/04/2019 2 of 9...
- Page 3 Hardware 90369 - Pedestal x2 58590 - Support Tube x1 P1 - Pedestal Box P1 - Support Tube P3 - H Support Tube P2 - U Clamp P6 - V Bracket: Inner A - M6 x 12mm P7 - V Bracket: Outer C - Set Screw A - M6 x 42mm D - Wood Screw...
-
Page 4: Warranty
WARNINGS AND DISCLAIMERS ADVERTENCIAS Y RENUNCIAS AVERTISSEMENTS Review full assembly instructions and Previo a comenzar el proceso de Avant de commencer l’ assamblage check that all parts are present before ensamblaje favor revisar veuillez consulter instructions beginning assembly. Heavy or large instrucciones y asegurarse que cuenta con complètes et vérifier si vous avez toutes furniture may require multiple persons in... - Page 5 STEP 1 Attach all four casters (C1,C2) to bottom of Pedestal Box (P1) by sliding in brackets and tightening with screw (A2). Do not install casters while resting pedestal on sliding brackets as this may cause brackets to bend. Locking Casters installed in front. Repeat step for second pedestal.
- Page 6 STEP 3 Connect V-bracket Inners (P2, P6) to Modesty Panel with two screws each (B). Keep top screw 3 holes or less from edge of panel to use desk at lowest setting. See picture for proper orientation. Hardware Required: -V-Bracket: Inner x2 90369(1) - P6 90369(2) - P6 -M6 x12mm x4...
- Page 7 STEP 5 Raise both pedestals to highest setting. Do this by pressing Hardware Required: levers on both sides while lifting. Set H-Supports on top of -H-Support Tube x2 both brackets. Make sure holes are oriented as shown. 90369(1) - P3 90369(2) - P3 Tool(s) Required: -Allen Wrench...
- Page 8 STEP 7 Set Table Top into place by aligning threaded inserts on Hardware Required: underside of table with holes in both H-Support tubes. Insert -M6 x 42mm x16 screws (A) up through holes and hand tighten all before 90369(1) - A x8 tightening further with allen wrench.
- Page 9 STEP 9 Install U-Clamps by sliding over Support Tube and securing with two wood screws each (D). Screws are driven directly into underside of table. Position clamps approximately half-way along each sliding tube. Hardware Required: -U-Clamp x2 58590 - P2 -Wood Screw x4 58590 - D Tool(s) Used...
Need help?
Do you have a question about the 90449 Series and is the answer not in the manual?
Questions and answers