Cisco Firepower 1010 Series Hardware Installation Manual page 49

Table of Contents

Installation, Maintenance, and Upgrade

•

Install the FIPS Opacity Shield

Note

Before you begin

Caution

You need the following to install the FIPS opacity shield:

• #1 Phillips head screwdriver

• The following items from the FIPS kit (part number 69-100649-01):

Install the FIPS Opacity Shield , on page 45

Because the FIPS opacity shield covers the serial number on the chassis, the CO should copy the serial number

and store it in a secure place. The serial number is needed when you call Cisco TAC. See

Digital Documentation Portal QR Code, on page 9

You can only install the FIPS opacity shield with the desktop mount or wall mount. The rack mount does not

support the FIPS shield. See

for more information.

This procedure should be performed only by the Crypto Officer (CO).

• One FIPS opacity shield (part number 800-106088-01)

• Three M3 x 66 mm (part number 48-0384-01) screws used to attach the FIPS opacity shield to the

chassis

• Nine Tamper Evidence Labels (TELs) (part number 47-25553-01)

C H A P T E R

for the location of the serial number.

Desktop-Mount the Chassis, on page 32

Cisco Firepower 1010 Series Hardware Installation Guide

Serial Number and

and

Wall-Mount the Chassis, on page

Table of Contents