Table of Contents
Advertisement
Installation and operation
Preparing and Dispensing Hot Water
1. Use hot water to prepare required beverages (tea, coffee, instant coffee,
bouillon, baby food, etc.).
Note: When preparing tea one must remember that brewing different types of
tea requires various water temperatures. Follow the instructions on packages.
Fig. 4
NOTE!
The appliance stores the last setting and the time until the desired water
temperature is reached if it is not unplugged.
If the plug is removed from the socket, this setting is lost.
Water Tank Filling
When the water in the water tank has been used up to the MIN mark, the appliance
stops preparing hot water, an audible signal is heard and the messages 'Lack of
water' and 'E7' appear. These messages mean that the water tank must be refilled
before hot water preparation can be restarted.
1. Before refilling switch the appliance off.
2. Remove the water tank lid.
3. Fill the water tank with fresh drinking water (only up to the MAX mark).
4. Replace the lid on the water tank.
200043
2. To dispense hot water, place a suitable
container (glass, cup or mug) under the
drain tube.
3. Select the desired temperature and amount
of water, observing indications in section
'Control Elements / Displayed Messages /
Settings'.
4. Press the Start/Stop key to start preparing
the water.
After approx. 5–10 seconds (depending on the
temperature setting), the selected amount of
water will flow from the drain tube.
5. If '000' was selected when setting the water
amount, press the Start/Stop key as soon as
the hot water is no longer needed.
6. To dispense hot water again, repeat the
process described above.
EN
17 / 22
Advertisement
Table of Contents
