Genelec 8000-450 Assembly Instruction

8000-450
The Genelec 8000-450 floor stand is designed to be
used with Genelec loudspeakers listed in Table 1. In
order to guarantee sufficient stability and safety, the
correct Genelec stand plate must always be used with
the 8000-450. These are listed in Table 1.
1. Start by attaching legs A together using the
triangular brackets. For legs A the attaching screws
are inserted from the inside into the threads on legs A.
Notice that bracket C with two captive nuts is attached
to the top.
2. Attach leg B with screws from the outside. The
triangular brackets have threaded captive nuts for this.
3. Attach the correct stand plate to the stand with a
screw (see Figure 3). Align the plate so that the leg
B with the groove for cables points away from the
listening position.
4. Place the loudspeaker on the plate and connect the
audio and mains cables. Use the magnetic holders to
run the cables tidily along the groove on leg B.
Loudspeaker model
8020, G Two, 8320
8030, G Three, 8330
8040, G Four, 8340
Table 1. Correct stand plates according to loudspeaker model
Stand plate order code
8020-408 (black)
8020-408W (white)
8030-408 (black)
8030-408W (white)
8040-408 (black)
8040-408W (white)
Assembly Instruction
Genelec 8000-450 Triol Floor Stand
A
B
Figure 1. Exploded view of the 8000-450. Notice that there
is one leg with a groove for cables (B) and two legs with no
groove (A) and the triangular bracket C is attached to the top
and D to the bottom
C
D
Figure 2. The triangular brackets hold the legs together.
Bracket C has two captive nuts and must be mounted at the
top position so the stand plate can be attached to the stand
(see Figures 1 and 3). The other captive nuts are used for
attaching leg B
C
A
D