Maintenance Schedule - AS MOTOR AS 1040 YAK 4WD Adjustment & Maintenance Manual

Maintenance schedule

Maintenance schedule
Hydrostatic oil change, same
maintenance interval as AS
940 Sherpa.
The implementation can be
found on page 33
.
WH AS 1040 YAK 4WD 01/2019 EN
Group Action
Check for safe working condition (basic view)
Machine
Cleaning
Service
Mower Clean. See chapter Cleaning mower
Fuel Tank, Fuel pipe Check fuel level
Is the fuel cap closed
Fuel Check leaks and good condition
Grill Cleaning
Cooling Cleaning
Ignition check/Replace
air filter Service
Check for wear and damage. See chapter Checking
the knife and flute shaft
Blade
change
Screw-on point Clean knife blade
The brake works safely and the knife stops in 7
Blade brake seconds
If the device is stationary when the lever is in neutral
position when the footbrake is applied
Drive Lever
Devices with foot brake: Does the lever go to zero
when the foot brake is applied?
Are the belts properly tensioned, with no cracks and
Belt in good condition?
Cabels Check function and ease of operation
accelerator check function
Chassis und
protection Check for rust and cracks and check the welds
Are all guards and covers in place, properly attached
and functional
Decals Decals readable
Binding information See operating instructions for
Engine engine manufacturers
Check oil level (see operating instructions engine
manufacturer)
Oil Change
Oil filter change
Parking brake check/Adjusting/change
Brake function of the brake
Flammable material Material remove
Steering check clearance
Tyre check Tyre and Tyre pressure
Safty switch seat, cutting height adjustment and travel drive
Ignition lock ceck function
Hydrostat TransmissioCheck oil level
eliminate oil leaks
Oil change after 50h afterwards all 200h
Battery Check charge status
A Before and after each use
B Annually or every 50 h
By the end user with the engine stopped
By the end user while the engine is running
authorized workshop
Page 8
Service
A B
www.as-motor.de