Preparation; Network And Poe - Bosch FLEXIDOME multi 7000i IR Installation Manual

FLEXIDOME multi 7000i IR
4.3

Preparation

Before installation, prepare and plan the installation process and materials needed.
Pre-requisites
–
–
4.4

Network and PoE++

Notice!
i
Camera supports PoE++ and PoE+
PoE 802.3bt Type 3 Class 5 with operating temperature -50 °C to +55 °C / -58 °F to +131 °F)
PoE 802.3at Type 2 Class 4 with operating temperature -20 °C to +55 °C / -4 °F to +131 °F)
Power-over-Ethernet Plus Plus (PoE++) can be connected at the same time as a 24V AC power
supply. If auxiliary power (24V AC) and PoE++ is applied simultaneously, the camera draws its
power from PoE++ by default, and seamlessly switches to auxiliary input if PoE++ fails.
When PoE++ returns, the camera seamlessly switches back to PoE++ as its default power
source.
The camera has an integrated heater. The heater works only when PoE 802.3bt Type 3 Class 5
is used. In this case, the camera functions in lower temperature (-50 °C / -58 °F).
Cables
For cable requirements, refer to Wiring the camera base, page 22 .
Bosch Security Systems B.V.
Quantity Component
1 Quick installation guide
1 Safety information
3 Installer UX labels
Remove the components from the box. Make sure that all parts are included and are not
damaged.
The necessary material and equipment:
– 4 screws M4 or M5 and mounting plugs M4 or M5 are necessary. For installation with
conduit (NDA-7051-CA), 5 screws M4 or M5 and mounting plugs M4 or M5 are
necessary.
– Appropriate size power drill.
– Screwdriver and bit holder for TR20 bit, or use the provided TR20 Allen key.
– microSD card (optional)
Note: Bosch recommends the use of industrial microSD cards with health
monitoring.
– Wireless USB dongle (NCA-WLAN) for wireless commissioning (optional) - available
2022.
Installation manual
Planning information | en
2023-02 | 02 |
13