Preparation In The Office; On-Site Commissioning; Lens Mounting - Bosch AVIOTEC IP starlight 8000 Operation And Commissioning Manual

AVIOTEC IP starlight 8000
4.2

Preparation in the office

We recommend that you prepare the installation in the office, as you can carry out many tasks
here that are not recommended under time pressure and possibly on lifting platforms etc.
We recommend that you carry out the following steps in advance:
1.
Unpack the camera and label it and the box with installation location and the later IP address.
1.
2.
3.
4.
5.
6.
7.
4.3

On-site commissioning

1.
2.
3.
4.
5.
4.4

Lens mounting

Notice!
Only use the supplied lens or approved lenses.
Do not use other lenses. A reliable functioning of the product cannot be guaranteed with
other lenses.
To attach the lens to the camera:
Bosch Sicherheitssysteme GmbH
Labeling camera + cardboard
Use PoE to power the camera.
Start the Configuration Manager and change the IP address of the camera according to
the plan. You can perform steps 3 to 8 using the Configuration Manager.
Change the passwords for the users "service", "live", "user". If necessary, you can also
create additional users.
Check that the firmware version installed on the camera is up to date and update it if
necessary. Always test the fire detection after updating to the latest firmware.
Set the current time and date and assign a camera name if required.
Change the fire detection settings as planned.
Adjust the recording settings if necessary.
Install the camera at the planned installation site
Adjust the opening angle as planned and align the camera.
Focus the camera image on the lens and then use the lens wizard to fine-tune the focus.
Optional: If necessary, adjust the settings for fire detection to the conditions on site
Document all settings and screenshots of the viewing area in the customer
documentation.
Operation and Commissioning Manual
Installation | en 19
2020.08 | 01 | F.01U.391.015