Rd Epampsim; Djfx Looper; Bpm Looper - Roland VERSELAB MV-1 Parameter Manual

MFX Parameters
Parameter Value
S Delay 1 Feedback -98–+98 [%]
200, 250, 315, 400, 500,
630, 800, 1000, 1250,
S HF Damp 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000,
BYPASS [Hz]
S Delay 1 Pan
S Delay 2 Pan
L64–63R
S Delay 3 Pan
S Delay 4 Pan
Level 0–127

81 RD EPAmpSim

This is an effect that was developed for the RD series SuperNatural
E.Piano.
L in
Bass/ Bass/
Overdrive Overdrive
Treble Treble
R in
Parameter Value
Bass -50–+50
Treble -50–+50
Tremolo Switch OFF, ON
OLDCASE MONO
OLDCASE STEREO
Tremolo Type
NEWCASE
DYNO
WURLY
Tremolo Speed
(sync
OFF, ON
sw)
Tremolo Speed 0.05–10.00 [Hz]
(Hz)
Note
Tremolo Speed
(note)
&
"Note"
(p. 51)
Tremolo Depth 0–127
Tremolo Shape 0–20
AMP Switch OFF, ON
LINE, OLD, NEW,
Speaker Type
WURLY, TWIN
OD Drive 0–127
Level 0–127
48
Explanation
Adjusts the proportion of the delay sound
that is fed back into the effect. Negative (-)
settings will invert the phase.
Adjusts the frequency above which the delay
sound fed back to the effect is filtered out
(BYPASS: no cut).
Panning of the first delay sound
Panning of the second delay sound
Panning of the third delay sound
Panning of the fourth delay sound
Output Level
L out
Speaker Speaker Tremolo Tremolo
R out
Explanation
Amount of low-frequency boost/cut
Amount of high-frequency boost/cut
Tremolo on/off
Type of tremolo effect
A standard electric piano sound of the early
70s (mono)
A standard electric piano sound of the early
70s (stereo)
A standard electric piano sound of the late
70s and early 80s
A classic modified electric piano
A classic electric piano of the '60s
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Rate of the tremolo effect
Depth of the tremolo effect
Adjusts the waveform of the tremolo.
Turns the speaker and distortion on/off
Type of speaker If LINE is selected, the
sound will not be sent through the speaker
simulation.
Degree of distortion
Also changes the volume.
Output Level

82 DJFX Looper

Loops a short portion of the input sound. You can vary the playback
direction and playback speed of the input sound to add turntable-type
effects.
L in
Delay Delay
Loop Sw
Loop Sw
R in
Delay Delay
Parameter Value
Length 0–127
Speed -1.00–+1.00
Loop Sw OFF, ON
Level 0–127

83 BPM Looper

Loops a short portion of the input sound. This can automatically turn
the loop on/off in synchronization with the rhythm.
L in
Delay Delay
R in
Delay Delay
Parameter Value
Length 0–127
Rate OFF, ON
(sync sw)
Rate Hz 0.05–10.00 [Hz]
Note
Rate Note
&
"Note" (p. 51)
On Timing 1–8
On Length 1–8
Loop Mode OFF, AUTO, ON
Level 0–127
L out
Loop Sw
Speed Speed
Control Control
Loop Sw
R out
Explanation
Specifies the length of the loop.
Specifies the playback direction and playback
speed.
- direction: Reverse playback
+ direction: Normal playback
0: Stop playback
As the value moves away from 0, the playback
speed becomes faster.
If you turn this on while the sound is heard,
the sound at that point will be looped. Turn
this off to cancel the loop.
* If the effect is recalled with this ON, this
parameter must be turned OFF and then turned
ON again in order to make the loop operate.
Output Level
L out
Loop Sw Loop Sw
Control Control
R out
Explanation
Specifies the length of the loop.
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Cycle at which the loop automatically turns
on/off
Specifies the timing within the cycle at which
the loop automatically starts (which step of
the eight timing divisions at which the sound
is heard)
Specifies the length at which the loop
automatically ends within the cycle (the
number of times that the 1/8-length of sound
is heard)
If this is AUTO, the loop automatically turns
on/off in synchronization with the rhythm.
* If the effect is recalled with this ON, this
parameter must first be set to something other
than ON in order to make the loop operate.
Output Level