Step Phaser; Multi Stage Phaser; Infinite Phaser; Ring Modulator - Roland VERSELAB MV-1 Parameter Manual

14 Step Phaser

This is a stereo phaser. The phaser effect will be varied gradually.
L in
Step Phaser Step Phaser
R in
Step Phaser Step Phaser
Parameter Value
4-STAGE, 8-STAGE,
Mode
12-STAGE
Manual 0–127
Rate OFF, ON
(sync sw)
Rate 0.05–10.00 [Hz]
(Hz)
Note
Rate
(note)
&
"Note" (p. 51)
Depth 0–127
Polarity INVERSE, SYNCHRO
Resonance 0–127
Cross Feedback -98–+98 [%]
Step Rate OFF, ON
(sync sw)
Step Rate 0.10–20.00 [Hz]
(Hz)
Note
Step Rate
(note)
&
"Note"
(p. 51)
Mix 0–127
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
Level 0–127

15 Multi Stage Phaser

Extremely high settings of the phase difference produce a deep phaser
effect.
L in
Multi Stage Multi Stage
Phaser Phaser
R in
Parameter Value
4-STAGE, 8-STAGE,
Mode 12-STAGE, 16-STAGE,
20-STAGE, 24-STAGE
Manual 0–127
Rate OFF, ON
(sync sw)
Rate 0.05–10.00 [Hz]
(Hz)
Note
Rate
(note)
&
"Note" (p. 51)
2-Band EQ 2-Band EQ
Mix
2-Band EQ 2-Band EQ
Mix
Explanation
Number of stages in the phaser
Center frequency at which the sound is
modulated
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Modulation rate
Depth of modulation
Selects whether the left and right phase
of the modulation will be the same or the
opposite.
INVERSE:
The left and right phase will be
opposite.
When using a mono source, this spreads the
sound.
SYNCHRO: The left and right phase will be
the same.
Select this when inputting a stereo source.
Amount of feedback
Adjusts the proportion of the phaser sound
that is fed back into the effect. Negative (-)
settings will invert the phase.
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Rate of the step-wise change in the phaser
effect
Level of the phase-shifted sound
Gain of the low range
Gain of the high range
Output Level
Pan L
2-Band EQ 2-Band EQ
Pan R
Mix
Explanation
Number of stages in the phaser
Center frequency at which the sound is
modulated
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Modulation rate
Parameter Value
Depth 0–127
Resonance 0–127
Mix 0–127
Pan L64–63R
L out Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
Level 0–127
R out

16 Infinite Phaser

A phaser that continues raising/lowering the frequency at which the
sound is modulated.
L in
R in
Parameter Value
Mode 1, 2, 3, 4
Speed -100–100
Resonance 0–127
Mix 0–127
Pan L64–63R
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
Level 0–127

17 Ring Modulator

This is an effect that applies amplitude modulation (AM) to the input
signal, producing bell-like sounds. You can also change the modulation
frequency in response to changes in the volume of the sound sent into
the effect.
L in
Ring Mod Ring Mod
R in
Ring Mod Ring Mod
Parameter Value
Frequency 0–127
Sens 0–127
L out
Polarity UP, DOWN
R out
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
Balance D100:0W–D0:100W
Level 0–127
Explanation
Depth of modulation
Amount of feedback
Level of the phase-shifted sound
Stereo location of the output sound
Gain of the low range
Gain of the high range
Output Level
Infinite Infinite
2-Band EQ 2-Band EQ
Phaser Phaser
Explanation
Higher values will produce a deeper phaser
effect.
Speed at which to raise or lower the
frequency at which the sound is modulated
(+: upward / -: downward)
Amount of feedback
Level of the phase-shifted sound
Stereo location of the output sound
Gain of the low range
Gain of the high range
Output Level
L out
2-Band EQ 2-Band EQ
R out
2-Band EQ 2-Band EQ
Explanation
Adjusts the frequency at which modulation is
applied.
Adjusts the amount of frequency modulation
applied.
Determines whether the frequency
modulation moves towards higher
frequencies or lower frequencies.
UP: The filter will change toward a higher
frequency.
DOWN: The filter will change toward a lower
frequency.
Gain of the low range
Gain of the high range
Volume balance between the direct sound (D)
and the effect sound (W)
Output Level
MFX Parameters
L out
Pan L
Pan R
R out
21