Figure 5 Connecting Serial Cables - TransAct POSjet 1500 Operator's Manual

®
The POSjet 1500 may be equipped with a number of different communications interface cards.
These interfaces include:
RS-232 Serial with 9-pin connector
RS-232 Serial with 25-pin connector
IEEE1284 Parallel with 25-pin connector (IEEE1284-A)
IEEE1284 Parallel with 36-pin Centronics style connector (IEEE1284-B)
USB
Connect the appropriate communications cable to the printer as shown in the following figures. Cables are provided
by your dealer, the system installer or are available through TransAct. If you are unsure of the interface installed in
your printer, refer to "Verifying the Communications Interface Card" on page 46.
1. Disconnect all power from the printer and host system or personal computer.
2. Connect the 9/25-pin Serial Interface Cable to the connector located on the back of the printer.
3. Tighten the two mounting screws on each side of the cable connector.
4. Route the Communication Cable through the Cable Restraint and connect the cable to your host system.

Figure 5 Connecting Serial Cables

Revision E
3 3 3 3
3
9