Quick Set Up Guide - Numatic NX300 Original Instructions Manual

!
PLEASE READ BEFORE COMMENCING ANY OPERATION. AFTER THE REMOVAL OF ALL
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
TTB 1840 36V CONTENTS
● Owner Manual
● Battery & Charger Manual
● Battery Charger & Lead
● Battery
● Scrub Brush
● Squeegee Assembly
3
Slide the brush / pad under the brush deck
(Fig.3).
6
Slide the battery into the
battery compartment (Fig.6)
!
1
Using the handle position lever, (Fig.1)
4
Fit the brush / pad onto the Nulock drive
chuck, twist to lock the brush / pad in
place (Fig.4).
7
Close the flexible lid making sure it is
sealed correctly. (Fig.7)
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
Quick Set-up Guide
!
2
Move the handle into the upright position,
(Fig.2)
5
Swing the floor-tool carrier from behind the
brush. Using the two locking knobs fitted
to the floor-tool, secure the
floor-tool to the floor-tool carrier (Fig.5).
8
Fill the clean-water tank to Max of 18 litres
5
!
!