Machine Set Up Guide - Numatic CRG 8055/100T Owner's Instructions Manual

! PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF
ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
CONTENTS
● Owner Manual ● Battery
Charging Lead ● 2 x Keys
● 40 Amp Fuse ● 30 Amp Fuse
● 20 Amp Fuse ● 10 Amp Fuse
● 4 Amp Fuse ● 2.5 Amp Fuse
● Maxi Fuse Puller
Lift top tank assembly to reveal battery
compartment, ensuring you use the
handle grip provided.
Fit battery fuse (contained in start-up
pack) into the battery fuse holder as
illustrated.
(Fig. 1, 2, 3.)
Insert Key into ignition located on the
control panel.
Note: Wear suitable gloves when
inserting fuses.
1
Less Battery Models - Numatic International Ltd recommends using MK or Sonnenschein Batteries for the 8055 & 8072 machines
mentioned in this manual. For full battery specifications see page 22.
ENSURE THAT NO METAL OBJECTS COME INTO CONTACT WITH BATTERY TERMINALS
!
WHEN INSERTING THE FIRST FUSE YOU MAY NOTICE A SPARK, THIS IS NORMAL.
Turn the key to switch on the
machine, set lever to forward.
Note: DO NOT depress accelerator pedal while software initialises. The machine will not operate in reverse with the floor
tool lowered. The seat is fitted with a pressure sensor that disables the machine until an operator is seated.
Use handle grip when
raising or lowering the
top waste-tank.
2
WHILE THE BATTERIES ARE EXPOSED.
Set to slowest speed, depress accelerator and
drive off the pallet using ramp provided.
Machine Set-up Guide
3
Once in a safe location switch off machine.
T 01460 68600
!
Fuse
!
5