Table of Contents
Advertisement
Machine Set-up Guide
GB
!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF
ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
CONTENTS
● Owner Manual
● Battery Charging Lead
● 2 x Keys
● 30 Amp Fuse
● 20 Amp Fuse
● 1 x 10 Amp Fuse
● 1 x 4 Amp Fuse
● 2.5 Amp Fuse
● Maxi Fuse Puller
Lift top tank assembly to reveal battery
compartment, ensuring you use the
handle grip provided.
Fit vacuum and brush fuses (contained
in start-up pack) into the fuse holders as
illustrated.
(Fig. 1)
Charge the machine to activate the
batteries. After the batteries were
activated, LEDs should illuminate on the
top of all the batteries.
Insert Key into ignition located on the
control panel (See (Fig. A)
Numatic International Ltd recommends
ONLY using 911948 NX1K LFP battery
type Lithium Batteries provided with this
machine.
20 Amp Fuse = Vac Motor
30 Amp Fuse = Brush Motor
10 Amp Fuse = Brush Engage
4 Amp Fuse = Water Pump
!
ENSURE THAT NO METAL OBJECTS COME INTO CONTACT WITH BATTERY TERMINALS
Turn the key to switch on the machine, set
lever to forward.
Note: DO NOT depress accelerator pedal while software initialises. The machine will not operate in reverse with the floor
tool lowered. The seat is fitted with a pressure sensor that disables the machine until an operator is seated.
Use handle grip when
raising or lowering the
top waste-tank.
1
20 Amp
WHILE THE BATTERIES ARE EXPOSED.
Set to slowest speed, depress accelerator
and drive off the pallet using ramp provided.
16
A
4 Amp
10 Amp
30 Amp
Insert the Ignition key and switch the
machine on. (Fig. A)
Once in a safe location switch off machine.
!
!
Advertisement
Table of Contents
