Machine Set Up Guide - Numatic CRG 8055/100T Original Instructions Manual

!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF ALL
CONTENTS
Owner Manual
●
Charging Lead
40 Amp Fuse 30 Amp Fuse
● ●
20 Amp Fuse 10 Amp Fuse
● ●
4 Amp Fuse 2.5 Amp Fuse
● ●
Maxi Fuse Puller
●
Lift top tank assembly to reveal battery
compartment, ensuring you use the handle
grip provided.
Fit battery fuse (contained in start-up pack)
into the battery fuse holder as illustrated.
(Fig. 1, 2, 3.)
Insert Key into ignition located on the
control panel.
NOTE: Wear suitable gloves when
inserting fuses.
1
Less Battery Models - Numatic International Ltd recommends using MK or Sonnenschein Batteries for the 8055 & 8072 machines
mentioned in this manual. For full battery specifications see page 22.
!
ENSURE THAT NO METAL OBJECTS COME INTO CONTACT WITH BATTERY TERMINALS
WHEN INSERTING THE FIRST FUSE YOU MAY NOTICE A SPARK, THIS IS NORMAL.
Turn the key to switch on the machine,
set lever to forward.
NOTE: DO NOT DEPRESS ACCELERATOR PEDAL WHILE SOFTWARE INITIALISES. The machine will not operate in reverse with the floor tool
lowered. The seat is fitted with a pressure sensor that disables the machine until an operator is seated.
8
www.numatic.co.uk
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
Battery
●
2 x Keys
●
Use handle grip when
raising or lowering the
2
WHILE THE BATTERIES ARE EXPOSED.
Set to slowest speed, depress accelerator and
drive off the palette using ramp provided.
top waste-tank.
Machine Set-up Guide
Fuse Location
3
Once in a safe location switch off machine.
!
!