Table of Contents
Advertisement
Using Basic Projector Features
Point Correction
This feature divides the projected image into a grid and corrects the distortion
in 0.5 pixel increments by moving the selected point of intersection from side
to side and up and down.
Execution Method
Settings > Geometry Correction > Point Correction
s
Screen Type
You can use the Screen Type setting to match the aspect ratio of the displayed
image to the screen you are using.
Execution Method
Extended > Display > Screen > Screen Type
s
• Adjust the aspect ratio for the projected image, if necessary.
• When the Screen Type setting changes, the EDID settings are
a
automatically adjusted.
Projection
You can change the projection mode to flip the image over top-to-bottom
and/or left-to-right using the projector menus.
Execution Method
Extended > Projection
s
You can change the projection mode to flip the image over top-to-
bottom by holding down the [A/V Mute] button on the remote control
for approximately 5 seconds.
a
Adjusting the Image Quality
This section provides instructions to adjust the quality of your image.
g g Related Links
• "Focus"
p.58
• "Color Mode"
p.59
• "Image Enhancement"
p.59
• "Gamma"
p.59
• "RGBCMY"
p.60
• "Brightness Settings"
p.60
Focus
You can correct the focus.
Execution Method
• Press the [Focus] button on the remote control.
• Press the [Lens] button on the control panel until the focus adjustment
screen is displayed.
58
Advertisement
Table of Contents
