Table of Contents
Advertisement
Signal Menu
You can change the projected image ratio to make the edges visible by a
selectable percentage or automatically.
Setting is only displayed when the input signal is component signal.
a
Blanking
Signal > Blanking
s
You can hide images in the specified area.
Use the arrow buttons on the control panel or remote control to adjust the
area. You can hide up to half of the projected image in each direction (except
for one pixel).
Setting is only displayed when the Content Playback setting is set to
Off in the projector's Settings menu.
a
Color Space
Signal > Color Space
s
You can switch the color space that can handle the color information of the
input image.
Select Auto to apply a suitable color space for the AVI InfoFrame of the
image.
Setting is only displayed in the following cases.
• The current source is HDMI, HDBaseT, DVI-D, or SDI
(EB‑PU2010B/EB‑PU2010W).
a
• Color Mode is set to other than BT.709 or DICOM SIM.
Dynamic Range
Signal > Dynamic Range
s
You can set the video range to match the setting of input source.
Select Auto to automatically identify the dynamic range of the input signal.
The result for your selected setting is displayed as Signal Status.
HDR10 Setting
You can adjust the PQ curve of the dynamic range in the HDR PQ
(Perceptual Quantizer) method.
HLG Setting
You can adjust the HLG curve of the dynamic range in the HDR HLG
(Hybrid Log Gamma) method.
• Setting is only displayed in the following cases.
• The current source is HDMI, HDBaseT, or SDI
a
(EB‑PU2010B/EB‑PU2010W).
• Color Mode is set to other than BT.709 or DICOM SIM.
• HDR10 Setting is only available when Signal Status is set to
HDR10.
• HLG Setting is only available when Signal Status is set to HLG.
Video Range
Signal > Advanced > Video Range
s
You can set the video range to match the setting of input source from the
HDMI, DVI-D, or HDBaseT port.
Limited (16-235)
For the brightness range 16 to 235.
Full (0-255)
For the brightness range 0 to 255.
77
Advertisement
Table of Contents
