Correcting Image Shape With Point Correction - Epson EB-810E User Manual

Image Shape
If you see this screen, you cannot adjust the shape any further in
the direction indicated by the gray triangle.
a
i Repeat steps 7 and 8 as needed to adjust any remaining corners.
j When you are finished, press [Esc].
• You can fine tune the corrected results. Use Quick Corner to adjust
the tilt of the image, and then use Point Correction for fine tuning.
Select Quick Corner or Point Correction on the screen in step 6.
a
• To save the current shape of an image you have adjusted, select Save
Memory. You can save up to three image shapes in the memory.
s Installation > Geometry Correction > Memory > Save Memory
• To reset the Arc Correction settings, hold down [Esc] for about 2
seconds while the area selection screen is displayed, and then select
Yes.
g g Related Links
• "Correcting the Image Shape with Quick Corner"
• "Correcting Image Shape with Point Correction"

Correcting Image Shape with Point Correction

You can use the projector's Point Correction setting to fine-tune the image
shape in portions of an image. The image is divided into a grid which allows
you to move intersection points on the grid as necessary to correct distortion.
If you change the Screen Type and Screen Position settings, the
adjustments are reset.
a
a Turn on the projector and display an image.
b
Press the [Menu] button on the control panel or remote control.
63
p.58
p.63