Table of Contents
Advertisement
Info Menu
You can display information about the projector and version by viewing the
Info menu. However, you cannot change any settings in the menu.
g g Related Links
• "Projector Info"
p.110
• "Light Source Info"
p.111
• "Version"
p.111
• "Status Information"
p.111
• "Voltage Warning Info"
p.112
• "Temp Warning Info"
p.112
• "Power On/Off History"
p.112
Projector Info
Info > Projector Info
s
You can view the projector's information.
Total Op. Time
Displays the number of hours the projector has been used in its operating
life.
Operation Hours
Displays the number of hours the projector has been used since it was
turned on.
The cumulative use time is displayed as "0H" for the first 10 hours. When
exceeding 10 hours, it is displayed as "10H" and "11H" in 1 hour units.
Source
Displays the name of the port to which the current input source is
connected.
Input Signal
Displays the input signal setting of the current input source.
Resolution
Displays the resolution of the current input source.
Refresh Rate
Displays the refresh rate of the current input source.
Sync Info
Displays information about video signals that may be needed by a service
technician.
Color Format
Displays the color format of the current input source.
Status
Displays information about projector problems that may be needed by a
service technician.
Serial Number
Displays the projector's serial number.
Lens Type
Displays the model number of the installed lens.
Event ID
Displays the Event ID number corresponding to a network problem; see
the list of Event ID codes.
HDBaseT Signal Level
Displays the signal level of the HDBaseT transmitter; if the information is
displayed in yellow, signal level is not enough.
g g Related Links
• "Event ID Code List"
p.110
Event ID Code List
If the Event ID option on the Projector Info menu displays a code number,
check this list of Event ID codes for the solution to the projector problem
associated with the code.
If you cannot resolve the problem, contact your network administrator or
Epson for technical support.
Event ID
Cause and solution
code
0432
The network software did not start. Turn the projector off and then
on again.
0435
0433
Cannot display the transferred images. Restart the network software.
110
Advertisement
Table of Contents
