Siemens SIMATIC NET RUGGEDCOM RX5000 Equipment Manual page 12

When the RUGGEDCOM RX5000 is configured for rack front mounting, these ports,
controls and LEDs are located on the front panel.
1
2
3
4
5
6
Figure 1.2
Power Supply Module Indicator
LEDs
Alarm Indicator LED
Lamp Test/Alarm Cut-Off (LT/
ACO) Button
Management Port
Utility USB Port
Compact Flash Card Port
RS232 Serial Console Port
RUGGEDCOM RX5000
Equipment Manual, 11/2023, C79000-G8976-1058-15
1
Power Supply Module Indicator LEDs
Alarm Indicator LEDs
Utility USB Port
Management Ethernet Port
Lamp Test/Alarm Cut-Off (LT/ACO) Button
RS232 Serial Console Port (DB9)
Front Panel
2
1
3 4 5 6
Indicate the status of the power modules.
• I = The power supply is receiving power
• O = The power supply is supplying power
Indicates when an alarm condition exists.
• Green = Alarms cleared/acknowledged
• Red = Alarm
This button performs two functions:
• Press and hold this button to test all indicator LEDs
• Press and release this button to acknowledge an active alarm
This 10/100Base-T Ethernet port is used for system management
that is out-of-band from the switch fabric.
Use the USB port to upgrade the RUGGEDCOM RUGGEDCOM
RX5000 software or install files, such as configuration files and
feature key files. For more information, refer to the "RUGGEDCOM
ROX II Configuration Manual" for the RUGGEDCOM RX5000.
Houses the CompactFlash (CF) card that contains active and
backup installations of RUGGEDCOM RUGGEDCOM RX5000,
along with the configuration database and other system data.
For more information, refer to "Accessing the CompactFlash
Card" (Page 39).
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device" (Page 37).
Introduction
1.2 Description
3