Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
•
6.1 Engine oil replacement
• Place engine on level surface to ensure accurate
• Before proceeding, perform the operation described in
NOTE:
Perform this operation with warm engine,
to get a better fluidity of the oil and get
a full discharge of oil and impurities
contained in it.
1. Loosen the oil filler cap A (Fig. 6.1).
2. Remove the oil dipstick B.
3. Remove the oil drain plug D and the gasket E
(the oil drain plug is on both sides of the oil sump).
4. Drain oil in an appropriate container (For the exhausted oil
disposal, refer to
5. Replace gasket E.
6. Tighten the drain oil plug D (tightening torque at 35 Nm).
7. Perform the operation described in
8. Add the type oil recommended
• Do not exceed the MAX level on the dipstick.
ED0053030050
_07
Index
INFORMATION ABOUT REPLACEMENTS
Before proceeding with operation, read
•
Important
measurement of oil level.
Par. 6.2
- Point 1.
(Par. 6.5 DISPOSAL and
SCRAPPING).
Par. 6.2
(Tab. 2.1 and Tab.
Important
Danger
Important
A
6.1
- point 2 to 5.
6.2
2.2).
6.3
Par.
3.3.2.
E
D
D
C
6
B
A
EN
29