Information About Replacements; Engine Oil Replacement - Kohler KDI 3404TCR-SCR Owner's Manual

6
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
•

6.1 Engine oil replacement

• Place engine on level surface to ensure accurate
measurement of oil level.
• Before proceeding, perform the operation described in
Par. 6.2
NOTE: Perform this operation with warm engine,
to get a better fluidity of the oil and get
a full discharge of oil and impurities
contained in it.
1. Loosen the oil filler cap A (Fig. 6.1).
2. Remove the oil dipstick B.
3. Remove the oil drain plug D and the gasket E
(the oil drain plug is on both sides of the oil sump).
4. Drain oil in an appropriate container (For the exhausted oil
(Par. 6.6 DISPOSAL and
disposal, refer to
5. Replace gasket E.
6. Tighten the drain oil plug D (tightening torque at 50 Nm).
7. Perform the operation described in
8. Add the type oil recommended
• Do not exceed the MAX level on the dipstick.
• Do not use the engine with the oil level below the MIN.
9. Fit and remove the oil dipstick B to check the level. Pour
in fluid until reaching the MAX level mark.
10. Upon completion, reinstall the oil dipstick B completely.
11. Tighten the cap A.
EN
36

INFORMATION ABOUT REPLACEMENTS

Before proceeding with operation, read
•
Important
- Point 1.
SCRAPPING).
Par. 6.2 - point 2 to 5.
(Tab. 2.1 and Tab.
Important
Danger
Important
A
6.1
6.2
2.2).
6.3
Par. 3.3.2.
B
E
D
MAX
MIN
ED0053032140
B
_02
Index