Installation Of The Flue Terminal - Winterwarm Qwikshift QSG Installation Manual

connected according to local and national regulations.
The following table describes the maximum amount of
condensate that can form per hour for each model:
Model
HR10 - HR20
HR30 - HR40
HR50 - HR60
HR80
HR100 - HR120

5.4. Installation of the flue terminal

There are flue terminals available for installation through a
roof or through a wall.
NOTICE The flue terminal must be installed according to
local and national regulations.
NOTICE Do not combine components or materials from
different manufacturers.
5.4.1. Installation - Roof terminal
To install the flue terminal in the roof, do the following:
5.4.1.1. Preparation
1. Check all components for possible damage.
2. Determine the roofing type:
Flat roof flashing Synthetic tile
Ø80 Ø130
IA8121
- 130 - 200
Ø100
IA8321
- 150
Ø130
IA8322
- 200
3. Determine where the flue terminal will be
positioned.
INSTALLATION MANUAL AIR HEATER TYPE QSG
Max. condensate rate (L/h)
2
3
4
6
8
Universal pitched
roof flashing.
IA8324
(5° - 25°)
Ø80
GA8334
IA8124
- 130
(25°
- 45°)
IA8143
Ø100
(25°
- 150
- 45°)
GA8342
Ø130
(22°
- 200
- 45°)
5.4.1.2. Installation
1. Create a hole from the outside of the roof.
CAUTION! Make sure no debris or dust gets into the air
heater.
2. Install the weather collar.
3. Carefully insert the flue terminal from the outside.
CAUTION! Do not rotate the cap.
4. Put the flue terminal into a vertical position. Use a
level.
5. OPTIONAL - If desired, fit cover plates. These are
supplied separately.
6. Place the supplied wall clamp around the flue
terminal and fit it to the roof construction. Do not
tighten the clamp yet.
7. Connect the gasket and the twin-tube connection.
Make sure that the gasket is not damaged.
NOTICE Make sure the flue tube and the air inlet tube are
not mixed up. The flue tube should be in the centre of the
flue terminal.
8. Tighten the roof wall clamp.
9. Check if all steps have been carried out correctly.
15