Quick Reference Table - Supermicro Storage SuperServer SSG-641E-E1CR36H User Manual

Quick Reference Table

Jumper Description
JBT1 CMOS Clear
JPL1 LAN1, LAN2 Enable/Disable
LED Description
LED4, LED7 M.2 LEDs (for M.2-C1, M.2-C2)
LED6 Unit Identifier (UID) LED
LEDBMC BMC Heartbeat LED
Power LED
LEDPWR
Connector
BT1
BMC_LAN
COM1
FAN1 - FAN6, FANA, FANB CPU/System Fan Headers
I-SATA0, I-SATA1
JBP_I2C1
JCOM2
JF1
JFP2
JIPMB1
JL1
JNCSI1
JNVI2C1
JPCIE1 (SLOT1),
JPCIE6 (SLOT6)
JPCIE2/3 (SLOT2/3),
JPCIE4/5 (SLOT4/5)
JPI2C1
JPWR1, JPWR2, JPWR4
JPWR3
JRK1
JS1 (SATA 0 - SATA7)
JSD1, JSD2
Status
Blinking Green: Device Working
Solid Blue: Unit Identified
Blinking Green: BMC Normal (Active),
Solid Green: (During BMC Reset or during a Cold Reboot)
LED On: Onboard Power On
Description
Onboard CMOS Battery
Dedicated BMC LAN Port
Rear I/O COM Port
Intel PCH Powered I-SATA 3.0 Ports with support of SuperDOM devices
*DOM: Disk on Module
4-pin BMC External I C Header
2
Front Accessible COM Port Header
Front Control Panel Header
Front Accessible VGA Connection Header
4-pin BMC External I C Header (for Inlet Temperature Sensor)
2
Chassis Intrusion Header
NC-SI (Network Controller Sideband Interface) Connector
NVMe SMBus I C Header with hot-plug support
2
PCIe 5.0 x8 Slots (SLOT1: supported by CPU1, SLOT6: supported by CPU2)
PCIe 5.0 x16 Slots (SLOT2/3: supported by CPU1, SLOT4/5: supported by CPU2)
Power System Management Bus (SMBus) I
8-pin Power Connectors
24-pin ATX Power Connector
Intel VROC Key Header for NVMe RAID support
SlimSAS x8 Connector with support of eight Intel PCH SATA 3.0 connections
(RAID 0, 1, 5, and 10 supported)
SATA DOM Power Connectors
18
Chapter 1: Introduction
Default Setting
Open (Normal)
Pins 1-2 (Enabled)
C Header
2