Supermicro Storage SuperServer SSG-641E-E1CR36H User Manual page 62

NCSI Connector
The Network Controller Sideband Interface (NCSI) connector is located at JNCSI1. The
connector is used to connect a Network Interface Card (NIC) to the motherboard to allow the
onboard BMC to communicate with a network.
Note: For detailed instructions on how to configure Network Interface Card (NIC) settings,
please refer to the Network Interface Card Configuration User's Guide posted on the web
page under the link: http://www.supermicro.com/support/manuals/.
SATA 3.0 Ports
The X13DEI-T has two SATA 3.0 ports (I-SATA0~1). These SATA ports are supported by the
Intel® C741 chipset. I-SATA0/1 can be used with Supermicro SuperDOMs which are orange
SATA DOM connectors with power pins built in, and do not require external power cables.
A slim SAS connector, located at JS1, supports eight SATA 3.0 connections (SATA0~7). These
SATA 3.0 ports are supported by the Intel® C741 chipset. Connecting a proper SATA cable
to JS1 to use SATA 3.0 connections.
DOM Power Connector
Two power connectors for SATA DOM (Disk-On-Module) devices are located at JSD1 and
JSD2. Connect appropriate cables here to provide power support for your Serial Link DOM
devices.
MCIO NVMe Connectors
MCIO NVMe connectors, located at JNVME1, JNVME2, and JNVME3. Each connector
provides two PCIe 5.0 x4 connections for a total of six connections. JNVME1 and JNVME2
connections are supported by CPU1. JNVME3 is supported by CPU2. Use these MCIO
connectors to support high-speed PCIe NVMe storage devices.
Note: When installing an NVMe device on a motherboard, please be sure to connect the first
NVMe port (JNVME1) first for your system to work properly.
Chapter 4: Motherboard Connections
DOM Power Connector
Pin Definitions
Pin# Definition
1 5 V
2 Ground
3 Ground
62